April 16, 2015

Tutorial, part 17 - Odds and Ends

Just a few loose ends to tie up ...

Fold the top 1" of the zipper out of the way and hand sew a hook-and-eye closure to the body facing, taking care to only sew through the facing (and seam allowances) and not stitching through to the right side of the garment!


NOTE: We recommend using one regular (medium) size hook-and-eye closure, although the screen-used uniforms seemed to have sometimes used one medium closure or two small ones. The choice is up to you! We've had better results with the single medium closure, though.


Put your jumpsuit on again and determine adequate pants' hem allowance. (The pattern's default pant leg hem allowance is 2").

Pin your hem allowance place if possible. (It helps to have a partner with this.)

Take your jumpsuit back off and press your pants' hem allowance upward.

Hand sew the hem allowance to the pant legs.

Press the bottom of the pant legs.


DS9/NEM cadet jumpsuit pictured
Cut two lengths of ¾" elastic for the "stirrup" at the bottom of the pant legs. 

The exact length needed may vary from person to person depending on the length of the pant legs and the width of the wearer's boots, but we generally recommend cutting these about 8" long. 

Sew the elastic stirrups to the bottom of the pant legs at the side seams with a triangular stitch (with the "flat" side of the triangle on bottom). 



(The above example was done in gray thread slightly darker than the jumpsuit body, so it's easier to see; done in matching thread it would be practically unnoticeable.) 


NOTE: Depending on the placement of the sole and shape of the bottom of your boots, you may find 1" elastic to be preferable and more effective than the ¾" pictured above. 


PREVIOUS: Tutorial, part 16 - Internal Belt

NEXT: Tips for Achieving an Ideal Fit

No comments:

Post a Comment